Guide de l'administrateur système APTARE IT Analytics

Téléchargez et installez Perl 5.6 (ou version ultérieure), si cela n'est pas déjà fait.

Installez NET-SNMP comme indiqué dans l'exemple suivant :

# /usr/local/bin/snmpconf -g basic_setup
*** Beginning basic system information setup ***
Do you want to configure the information returned in the system MIB group
(contact info, etc)? (default = y): no
Do you want to properly set the value of the sysServices.0 OID (if you don't know, just say no)? (default = y): no
*** BEGINNING ACCESS CONTROL SETUP ***
Do you want to configure the agent's access control? (default = y):
Do you want to allow SNMPv3 read-write user based access (default = y): no
Do you want to allow SNMPv3 read-only user based access (default = y): no
Do you want to allow SNMPv1/v2c read-write community access (default = y): no
Do you want to allow SNMPv1/v2c read-only community access (default = y): yes
Configuring: rocommunity
Description:
a SNMPv1/SNMPv2c read-only access community name arguments: community [default|hostname|network/bits] [oid]
The community name to add read-only access for: public
The hostname or network address to accept this community name from [RETURN for all]:
The OID that this community should be restricted to [RETURN for norestriction]:
Finished Output: rocommunity public
Do another rocommunity line? (default = y): no
*** Beginning trap destination setup ***
Do you want to configure where and if the agent will send traps? (default= y): no
*** Beginning monitoring setup ***
Do you want to configure the agent's ability to monitor various aspects of your system? (default = y): no
The following files were created:
snmpd.conf

Déplacez le fichier snpd.conf vers l'un des emplacements suivants :

Assurez-vous que l'utilisateur racine exécute le fichier exécutable snmpd se trouvant dans /usr/local/sbin/snmpd.