Please enter search query.
Search <book_title>...
Veritas NetBackup™ 52xx Appliance Initial Configuration Guide
Last Published:
2019-06-26
Product(s):
Appliances (3.0)
Platform: 5220,5230,5240
- Preparing for initial configuration
- About appliance configuration guidelines
- About appliance system configuration sequence
- About NetBackup 52xx appliance roles
- About IPv4-IPv6-based network support
- Overview of the initial configuration pages in the NetBackup Appliance Web Console
- About the NetBackup appliance initial configuration checklist
- About configuring the maximum transmission unit size
- Initial configuration procedures
- Performing the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console
- Performing the initial configuration on a 52xx master server appliance from the NetBackup Appliance Shell Menu
- Configuring a master server to communicate with an appliance media server
- Performing the initial configuration on a 52xx media server appliance from the NetBackup Appliance Shell Menu
- Post configuration procedures
Command limitations on appliances that are not configured
Before an appliance can be managed, it must first be configured. The commands that are used for initial configuration are the only valid commands that can be executed on a new appliance, or a factory reset appliance. Commands other than those used for the initial configuration can exhibit unexpected or undesired behavior. To prevent this situation, Veritas recommends that you avoid using any management commands until after the appliance initial configuration has been completed.
For information on valid commands for appliances that are not configured, refer to the following documents:
NetBackup Appliance Initial Configuration Guide
NetBackup Appliance Commands Reference Guide