Veritas Access Appliance Initial Configuration and Administration Guide
- Getting to know the Access Appliance
- Preparing to configure the appliance
- Configuring the appliance for the first time
- Getting started with the Veritas Access GUI
- Storage management
- Network connection management
- Configuring network address settings on the appliance nodes
- About VLAN tagging on the appliance
- Configuring static routes on the appliance
- Configuring DNS and host name mapping on the appliance
- About the maximum transmission unit size on the appliance
- About the Veritas Remote Management Console
- Setting the date and time on the appliance
- Monitoring the appliance
- Resetting the appliance to factory settings
- Appliance security
- About Access Appliance security
- About Access appliance user account privileges
- Changing the Maintenance user account password
- About the Access Appliance intrusion detection system
- About Access appliance operating system security
- About data security on the Access appliance
- About data integrity on the Access appliance
- Recommended IPMI settings on the Access appliance
- Troubleshooting
About the appliance storage
The Veritas Access 3340 Appliance must be connected to one Primary Storage Shelf. The storage space can be expanded by using up to three Expansion Storage Shelves. After you have physically connected the storage shelves, use the Access Appliance shell menu to discover and refresh the storage devices information. All the appliance nodes share the external storage that is attached to the appliance.
Note:
The Veritas Access 3340 compute nodes do not have internal disk space available for Access storage. Only the space available on the Primary Storage Shelf and Expansion Storage Shelves can be used for Access data.
The physical disk storage in the Primary Storage Shelf contains five Data volumes, five Fencing volumes, and one Configuration volume.
The physical disk storage in the Expansion Storage Shelf contains five Data volumes.
The Data, Fencing, and Configuration volumes are created when you scan the storage that is attached to the appliance. The Access software only uses the Data volumes to provision storage.