Veritas NetBackup™ Flex Scale Installation and Configuration Guide

Last Published:
Product(s): Appliances (1.3.1)
Platform: NetBackup Flex Scale OS
  1. Preparing for NetBackup Flex Scale deployment
    1.  
      Deployment overview
    2.  
      NetBackup Flex Scale configuration requirements
    3.  
      Firewall and network ports requirements
    4.  
      Considerations for using IPv6 addresses
  2. Configuring NetBackup Flex Scale
    1.  
      Assigning a public IP address to network adapter eth1 of a node
    2.  
      NetBackup Flex Scale configuration methods
    3.  
      Configuring NetBackup Flex Scale using the setup wizard
    4. Configuring NetBackup Flex Scale using a configuration file
      1.  
        YML configuration file
  3. Troubleshooting NetBackup Flex Scale deployment
    1.  
      NetBackup Flex Scale logs
    2.  
      Connection timeout errors during patch installs, upgrades, and rollback operations
    3.  
      Initial configuration wizard displays a driver node not selected error
    4.  
      Initial configuration wizard displays a license error after successfully configuring the cluster
  4. NetBackup Flex Scale upgrades and patch management
    1. About NetBackup Flex Scale upgrades and EEB
      1.  
        Pre-upgrade steps
    2.  
      Performing a patch upgrade using GUI
    3.  
      Installing EEBs using GUI
    4.  
      Performing a patch upgrade using REST APIs
    5.  
      Installing EEBs using REST APIs
  5. Removing NetBackup Flex Scale
    1. About disk erasure
      1.  
        Configuring data erasure
      2.  
        Viewing the data erasure status
      3.  
        Aborting data erasure
    2.  
      About NetBackup Flex Scale node factory reset
    3.  
      Performing a factory reset on a node
  6. Appendix A. Installing NetBackup Flex Scale
    1.  
      About NetBackup Flex Scale software installation
    2.  
      Enabling remote IPMI connections
    3.  
      Setting up the RAID configuration on the nodes
    4.  
      Configuring the BIOS settings on the nodes
    5.  
      Downloading the product installer ISO
    6.  
      Mounting the ISO file on the nodes
    7.  
      Installing NetBackup Flex Scale using the ISO

Connection timeout errors during patch installs, upgrades, and rollback operations

While performing maintenance activities such as EEB patch installation, software upgrade, or rollback on your NetBackup Flex Scale cluster, the operations may fail with a connection timeout error.

The following message may appear in the product logs:

ERROR Unable to connect to <cluster node #>: [Errno 110] Connection timed out

Cause

This error typically occurs if the network interface eth4 is down on any of the cluster nodes. NetBackup Flex Scale uses eth4 for communication between the cluster nodes. Whenever eth4 is down, it breaks that communication path and all ssh commands fail to execute with a timeout error.

Solution

Ensure that the network interface eth4 is up on each of the cluster nodes and then perform the maintenance tasks in the cluster.