Veritas NetBackup™ Flex Scale Installation and Configuration Guide

Last Published:
Product(s): Appliances (1.3.1)
Platform: NetBackup Flex Scale OS
  1. Preparing for NetBackup Flex Scale deployment
    1.  
      Deployment overview
    2.  
      NetBackup Flex Scale configuration requirements
    3.  
      Firewall and network ports requirements
    4.  
      Considerations for using IPv6 addresses
  2. Configuring NetBackup Flex Scale
    1.  
      Assigning a public IP address to network adapter eth1 of a node
    2.  
      NetBackup Flex Scale configuration methods
    3.  
      Configuring NetBackup Flex Scale using the setup wizard
    4. Configuring NetBackup Flex Scale using a configuration file
      1.  
        YML configuration file
  3. Troubleshooting NetBackup Flex Scale deployment
    1.  
      NetBackup Flex Scale logs
    2.  
      Connection timeout errors during patch installs, upgrades, and rollback operations
    3.  
      Initial configuration wizard displays a driver node not selected error
    4.  
      Initial configuration wizard displays a license error after successfully configuring the cluster
  4. NetBackup Flex Scale upgrades and patch management
    1. About NetBackup Flex Scale upgrades and EEB
      1.  
        Pre-upgrade steps
    2.  
      Performing a patch upgrade using GUI
    3.  
      Installing EEBs using GUI
    4.  
      Performing a patch upgrade using REST APIs
    5.  
      Installing EEBs using REST APIs
  5. Removing NetBackup Flex Scale
    1. About disk erasure
      1.  
        Configuring data erasure
      2.  
        Viewing the data erasure status
      3.  
        Aborting data erasure
    2.  
      About NetBackup Flex Scale node factory reset
    3.  
      Performing a factory reset on a node
  6. Appendix A. Installing NetBackup Flex Scale
    1.  
      About NetBackup Flex Scale software installation
    2.  
      Enabling remote IPMI connections
    3.  
      Setting up the RAID configuration on the nodes
    4.  
      Configuring the BIOS settings on the nodes
    5.  
      Downloading the product installer ISO
    6.  
      Mounting the ISO file on the nodes
    7.  
      Installing NetBackup Flex Scale using the ISO

Initial configuration wizard displays a license error after successfully configuring the cluster

You can add a NetBackup Flex Scale storage license or a NetBackup license while configuring the cluster. The initial configuration wizard displays a license page where you can specify the license details. However, entering the licenses during the cluster configuration itself is not mandatory. In case you skip the licensing page, the cluster is automatically configured with an in-built trial license. After the cluster configuration is successful, the wizard displays the following message:

No valid storage license is provided. A valid license is required to maintain a working cluster. Please add storage licenses after cluster configuration from appliance web GUI.

Cause

While this error message is harmless and does not affect the cluster, it is displayed as a reminder that you must add a valid license in order to maintain a working cluster configuration.

Solution

You can use the NetBackup Flex Scale infrastructure management console UI to add a license. Veritas recommends that you add proper licenses before you start protecting production workloads with your appliance.