Veritas NetBackup™ for Sybase Administrator's Guide
- Introduction to NetBackup for Sybase
- Installing NetBackup for Sybase
- Configuring NetBackup for Sybase
- About configuring a backup policy for Sybase
- About the backup, restore, and load scripts for NetBackup for Sybase on UNIX
- About the backup, restore, and load scripts for NetBackup for Sybase on Windows
- NetBackup for Sybase configuration or bp.conf file settings
- About striped dumps and loads with NetBackup for Sybase
- Using NetBackup for Sybase
- Troubleshooting NetBackup for Sybase
- NetBackup debug logs and reports
- NetBackup debug logs and reports
- Appendix A. Register authorized locations
Adding clients to a policy
The client list contains a list of the clients on which your scripts are run during an automatic backup or the clients that can send backup requests to the application schedule. A NetBackup client must be in at least one policy but can be in more than one.
For a NetBackup for Sybase policy, clients you want to add must have the following items installed or available:
Sybase
NetBackup client or server
The backup or restore Sybase scripts
To add clients to a NetBackup for Sybase policy
- Open the policy you want to edit or create a new policy.
To access the Policy dialog box, double-click the policy name in the Policies list in the NetBackup Administration Console.
- Click the Clients tab.
- Click New.
- Type the name of the client and select the hardware and operating system of the client.
If Sybase is installed in a cluster, specify the virtual name of the Sybase server as the client name.
Note:
If you installed NetBackup on more than one node in the Sybase cluster, you must perform additional configuration.
See Reviewing the auto-discovered mappings in Host Management.
- Choose one of the following:
To add another client, click Add.
If this client is the last client you want to add, click OK.
- In the Policy dialog box, click OK.