Veritas NetBackup™ Appliance Administrator's Guide

To configure Fibre Transport to other NetBackup appliances from the NetBackup Appliance Web Console

1. Log on to the NetBackup Appliance Web Console.
2. Click Settings > Network, then select Fibre Transport.
3. To enable the feature, click Enable Fibre Transport for replication to other NetBackup Appliances, then click Save.

   When the message appears to inform you of the required appliance version, click OK to continue or click Cancel to exit without making changes.

   Note:

   You must also enable FC communication on the associated NetBackup appliance.

   On a target NetBackup 52xx or 53xx, you must enable that appliance as a replication target to use it as the storage destination.

4. To disable the Fibre Transport to other NetBackup Appliances option, deselect the check box to clear the check mark. Then, click Save.

To configure Fibre Transport to other NetBackup appliances from the NetBackup Appliance Shell Menu (5350 model with software versions 4.0 and later, all other supported models with software versions 4.1 and later)

1. Log on to the appliance shell menu.
2. To enable the feature, run the following command:

   Main > Settings > FibreTransport Initiator Enable

3. To disable the feature, run the following command:

   Main > Settings > FibreTransport Initiator Disable

4. To check the current settings, run the following command:

   Main > Settings > FibreTransport Initiator Show