Veritas NetBackup™ 52xx Appliance Initial Configuration Guide
- Preparing for initial configuration
- About appliance configuration guidelines
- About appliance system configuration sequence
- About NetBackup 52xx appliance roles
- About IPv4-IPv6-based network support
- Overview of the initial configuration pages in the NetBackup Appliance Web Console
- About the NetBackup appliance initial configuration checklist
- About configuring the maximum transmission unit size
- Initial configuration procedures
- Performing the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console
- Performing the initial configuration on a 52xx master server appliance from the NetBackup Appliance Shell Menu
- Configuring a master server to communicate with an appliance media server
- Performing the initial configuration on a 52xx media server appliance from the NetBackup Appliance Shell Menu
- Post configuration procedures
Overview of the initial configuration pages in the NetBackup Appliance Web Console
The NetBackup Appliance Web Console lets you perform the initial configuration through a series of pages where you enter the appropriate information. The following shows each page along with a brief description of the required information.
This page appears when you log on to an appliance that is not configured. It provides a short summary of the necessary information for the initial configuration.
Note:
This page provides a link to download a checklist that provides descriptions for all of the data entry fields on all pages in the initial configuration. Before you begin the initial configuration, Veritas recommends that you click on the link, print the file, and record all of the necessary information.
This page is used to enter your corporate network information. The upper table contains tabs for entering the Interface Properties and the Routing Properties information. The lower table contains drop down tabs that expand to enter the Create Bond, Tag VLAN, and Add Static Route information.
This page is used to enter the host identification information for this appliance. The appliance host name (FQDN and short name), the IP address, and the domain name are all required.