Search <book_title>...

NetBackup™ Self Service Installation Guide

Last Published: 2022-03-28

Product(s): NetBackup (10.0)

Introduction
1. About Self Service components
Prerequisites
1. About prerequisites
Installation
Upgrade
Post-installation validation
Uninstallation
1. Uninstalling NetBackup Self Service
Appendix A. Software requirements
1. NetBackup software requirements for Self Service
Appendix B. Troubleshooting
1. About PowerShell execution policy
2. Recovering a lost application key
Appendix C. Default HTTPS configuration
1. About the default HTTPS configuration
Appendix D. Load balanced installation
1. About load-balanced installation
Appendix E. Customizing image upload
1. About Customizing Image Upload
Appendix F. Reduced Database Permissions for Database Upgrade
1. Reduced Database Permissions for Database Upgrade

Post upgrade steps

After the upgrade finishes, complete a connectivity check for all master servers.

Veritas also recommends that you re-synchronize all data.

As part of the upgrade, the two databases were backed up and the recovery model was set to Simple. Revert the database's recovery model to its initial value.

To revert the database to its initial value:

Shrink both databases.
Set the recovery model of the databases back to its original value.

When an upgrade is performed a new set of code is placed in a new location on the server. Once the upgrade is complete, remove the old installation.

To remove old installation code

Go to Add/Remove Programs.
Uninstall any previous versions of:
- NetBackup Self Service Portal
- NetBackup Self Service Adapter