Please enter search query.
Search <book_title>...
Veritas NetBackup™ 5240 Appliance Hardware Installation Guide
Last Published:
2020-05-06
Product(s):
Appliances (Version Not Specified)
Platform: Veritas 5240
- Hardware overview
- Preinstallation requirements
- Installation procedures
- Appendix A. Adding one or more storage shelves to an operating appliance that does not have any storage shelves
- Appendix B. Adding storage shelves to an operating appliance that has at least one storage shelf attached
- Appendix C. Adding the disk space of additional storage shelves
Removing the appliance cover
The appliance cover must be removed to install the components of the Expansion Storage Kit.
Caution:
Veritas service personnel must perform all tasks that involve the inside of the appliance chassis.
To remove the cover
If the top of the appliance looks like this
Do the following:
Remove the three screws on the top of the cover as shown in the illustration.
Completely loosen the two thumb screws (circled) on the rear of the chassis cover.
Press down on the blue thumb grips and slide the cover back 0.5 inches.
Lift the cover off the chassis and set it aside where it cannot be damaged.
- Proceed to install the storage kit components into the appliance.