Please enter search query.
Search <book_title>...
Veritas Access Appliance Initial Configuration and Administration Guide
Last Published:
2018-07-02
Product(s):
Appliances (7.3.2)
Platform: 3340
- Getting to know the Access Appliance
- Preparing to configure the appliance
- Configuring the appliance for the first time
- Getting started with the Veritas Access GUI
- Storage management
- Network connection management
- Configuring network address settings on the appliance nodes
- About the Veritas Remote Management Console
- Monitoring the appliance
- Resetting the appliance to factory settings
- Appliance security
- About Access appliance user account privileges
- About the Access Appliance intrusion detection system
- About Access appliance operating system security
- Recommended IPMI settings on the Access appliance
- Troubleshooting
Configuring network address settings on the appliance nodes
You can configure the network settings for eth0 and eth1 of an appliance node.
To configure the appliance node to communicate with one network
- Log on to the Access Appliance shell menu on the desired node.
- From the Main_Menu > Network view, type the following command to verify which network ports and bonds are plugged and available for configuration:
Show Status
- Type the following command to configure the appliance to connect to a single network:
Configure <IPAddress> <Netmask> <GatewayIPAddress> <InterfaceNames>
<IPAddress> - The new IPv4 address that you want to assign to the network interface.
<Netmask> - The subnet mask (IPv4).
<GatewayIPAddress> - The default gateway for the appliance node.
<InterfaceNames> - The network port that you want to assign the configuration to, such as eth1.
For example:
Configure 10.182.20.255 255.255.224.0 10.182.1.1 eth1