Veritas 5150 Appliance Product Description Guide

• System power is off (AC and/or DC)

• System is in EuP Lot6 Off Mode

• System is in S5 Soft-Off State

System degraded:

• Redundant loss, such as power supply or fan. Applies only if the associated platform sub-system has redundancy capabilities.

• Fan warning or failure when the number of fully operational fans is more than minimum number needed to cool the system.

• Non-critical threshold crossed: Temperature (including HSBP temp), voltage, input power to power supply, output current for main power rail from power supply and Processor Thermal Control (Therm Ctrl) sensors.

• Power supply predictive failure occurred while redundant power supply configuration was present.

• Unable to use all of the installed memory (more than one DIMM is installed).

• Correctable errors over a threshold and migrating to a spare DIMM (memory sparing). This indicates that the system has no spared DIMMs (a redundancy lost condition). The corresponding DIMM LED also lights up.

System degraded: (continued)

• In mirrored configuration, when memory mirroring takes place and system loses memory redundancy.

• Battery failure

• BMC executing in uBoot. (Indicated by Chassis ID blinking at 3Hz). System in degraded state (no manageability). BMC uBoot is running but has not transferred control to the BMC Linux. Server will be in this state 6-8 seconds after BMC reset while it pulls the Linux image into flash.

• BMC booting Linux. (Indicated by Chassis ID solid ON). System in degraded state (no manageability). Control has been passed from BMC uBoot to BMC Linux itself. It will be in this state for 10-20 seconds.

• BMC Watchdog has reset the BMC.

• Power unit sensor offset for configuration error is asserted.

• Hard disk drive HSC is offline or degraded.

Non-fatal, although the system is likely to fail due to the following issues:

• Critical threshold crossed - Voltage, temperature (including HSBP temp), input power to power supply, output current for main power rail from power supply and PROCHOT (Therm Ctrl) sensors.

• VRD Hot asserted

• Minimum number of fans to cool the system not present or failed

• Hard drive fault

• Power Unit Redundancy sensor - Insufficient resources offset (indicates not enough power supplies present)

• Correctable memory error threshold has been reached when the system is operating in a non-sparing and non-mirroring mode.

Fatal alarm - system has failed or shutdown:

• CPU CATERR signal asserted

• MSID mismatch detected (CATERR also asserts for this case)

• CPU1 is missing

• CPU Thermal Trip

• No power - power fault

• DIMM failure when there is only one DIMM present; no other good DIMM memory present

• Run time memory uncorrectable error in non-redundant mode.

• DIMM Thermal Trip or equivalent

• SBB Thermal Trip or equivalent

• CPU ERR2 signal is asserted

• BMC/Video memory test failed (Chassis ID shows blue/solid-on for this condition)

• Both uBoot BMC FW images are bad (Chassis ID shows blue/solid-on for this condition)

• 240 VA fault

• Fatal error in processor initialization:

  • Processor family not identical

  • Processor model not identical

  • Processor core/thread counts not identical

  • Processor cache size not identical

  • Unable to synchronize processor frequency

  • Unable to synchronize QPI link frequency

• Uncorrectable memory error in non-redundant mode