Veritas NetBackup™ Installation Guide
- Preparing for installation
- General installation information
- How to install NetBackup
- About storage device configuration
- Installation operational notes and limitations
- SORT information
- Smart Meter information
- General installation information
- NetBackup licenses
- Installing server software on UNIX systems
- Installation and upgrade requirements for UNIX and Linux
- Installing NetBackup master server software on UNIX
- Installing NetBackup media server software on UNIX
- About pushing client software from a master server to clients
- Installation and upgrade requirements for UNIX and Linux
- Installing server software on Windows systems
- About the administrative interfaces
- Installing NetBackup client software
- About NetBackup client installation on Windows
- About NetBackup client installation on UNIX/Linux
- About remote installation methods for UNIX/Linux clients
- Configuring NetBackup
- Upgrading NetBackup software
- Removing NetBackup server and client software
- Reference
About Windows client installation methods and requirements
You can install NetBackup clients on Windows systems with the following methods:
Table: Installation methods and requirements
Method | Requirements | Details |
---|---|---|
To install NetBackup client software locally, the system must meet the following configuration requirements:
| The installation wizard installs the client software only on the computer where you run the installation. See Installing NetBackup Windows clients locally or remotely. | |
To install NetBackup client software remotely, the system must meet the following configuration requirements:
| The installation wizard scans the network for available clients where you can install the client software. The source computer must run Windows 2008, 2008 R2, 2012, or 2016 Server. Also, a remote installation requires system administrator privileges. Note: You cannot install clients remotely from NetBackup Windows servers to UNIX computers. See Installing NetBackup Windows clients locally or remotely. | |
The requirements for silent installation are the same as the requirements for a local installation. | A silent installation is a process that does not require interactive input. However, you must edit the silentclient.cmd file before you run it. |
An NTFS disk partition is required for all installation types.
The NetBackup client version that you install must be the same or earlier than the installed version of NetBackup server software. Later client versions cannot be used with earlier server versions.
More Information