Guide d'installation d'APTARE IT Analytics Data Collector pour Backup Manager

Téléchargez et installez Perl 5.6 (ou version ultérieure), si cela n'est pas déjà fait.

Installez NET-SNMP comme indiqué dans l'exemple suivant :

  
     # /usr/local/bin/snmpconf -g basic_setup
     *** Beginning basic system information setup ***
     Do you want to configure the information returned in the system MIB group
     (contact info, etc)? (default = y): no
     Do you want to properly set the value of the sysServices.0 OID (if you don't know, just say no)? (default = y): no
     *** BEGINNING ACCESS CONTROL SETUP ***
     Do you want to configure the agent's access control? (default = y):
     Do you want to allow SNMPv3 read-write user based access (default = y): no
     Do you want to allow SNMPv3 read-only user based access (default = y): no
     Do you want to allow SNMPv1/v2c read-write community access (default = y): no
     Do you want to allow SNMPv1/v2c read-only community access (default = y): yes
     Configuring: rocommunity
     Description:
     a SNMPv1/SNMPv2c read-only access community name arguments: community [default|hostname|network/bits] [oid]
     The community name to add read-only access for: public
     The hostname or network address to accept this community name from [RETURN for all]:
     The OID that this community should be restricted to [RETURN for norestriction]:
     Finished Output: rocommunity public
     Do another rocommunity line? (default = y): no
     *** Beginning trap destination setup ***
     Do you want to configure where and if the agent will send traps? (default= y): no
     *** Beginning monitoring setup ***
     Do you want to configure the agent's ability to monitor various aspects of your system? (default = y): no
     The following files were created:
     snmpd.conf

Déplacez le fichier snpd. conf vers l'un des emplacements suivants :

Assurez-vous que l'utilisateur racine démarre le fichier exécutable SNMP situé dans /usr/local/sbin/snmpd.