Please enter search query.
Search <book_title>...
Veritas NetBackup™ 8.0 for VMware Administrator's Guide
Last Published:
2017-07-13
Product(s):
NetBackup (8.0)
- Introduction
- Required tasks: overview
- Notes and prerequisites
- Configure NetBackup communication with VMware
- Configure NetBackup policies for VMware
- VMware backup options
- Configure a VMware Intelligent Policy
- Reduce the size of backups
- Back up virtual machines
- Use Accelerator to back up virtual machines
- Restore virtual machines
- Restoring the full VMware virtual machine
- Virtual Machine Recovery dialog boxes (restore to original location)
- Virtual Machine Recovery dialogs boxes (restore to alternate location)
- Restoring VMware virtual machine disks
- Restoring individual files
- Browse and search virtual machines for restore
- Restore virtual machines with Instant Recovery
- Use NetBackup for vCloud Director
- Virtual machine recovery dialog boxes for vCloud Director
- Best practices and more information
- Troubleshooting
- Appendix A. NetBackup commands to back up and restore virtual machines
- Using NetBackup commands to create a VMware policy
- Appendix B. Configuring services for NFS on Windows
- About configuring services for NFS on Windows 2012 (NetBackup for VMware)
- About configuring services for NFS on Windows 2008 and 2008 R2 (NetBackup for VMware)
- About configuring Services for Network File System (NFS) on the Windows 2003 R2 SP2 NetBackup media server and NetBackup clients (NetBackup for VMware)
- Appendix C. The Reuse VM selection query results option
- Appendix D. Backup of VMware raw devices (RDM)
- Appendix E. SYMCquiesce utility for Linux virtual machines
Adding the VMware backup host to NetBackup
Use this procedure to enable a NetBackup client as the backup host.
Note:
This procedure is not needed for the media servers that operate as backup hosts with the policy Backup Media Server option. With that option, NetBackup automatically enables media servers as backup hosts.
In the NetBackup Administration Console, do the following.
To add the VMware backup host
- Click Host Properties > Master Servers, double click the NetBackup master server, and click VMware Access Hosts.
- Click Add.
- Enter the fully qualified domain name of the VMware backup host, and click Add.
- When you are finished adding hosts, click Close.
- Click Apply and then OK.
- If the NetBackup master server is clustered in a failover environment: repeat this procedure to add the backup host to each master server node in the cluster.
More Information