Veritas Access Appliance Command Reference Guide
- Overview
- Appendix A. Main > Appliance
- Appendix B. Main > Manage > Cluster
- Appendix C. Main > Manage > Software
- Appendix D. Main > Manage > Storage
- Appendix E. Main > Network
- Network > Configure
- Network > Date
- Network > DNS
- Network > Gateway
- Network > Hosts
- Network > IPv4
- Network > IPv6
- Network > SetProperty
- Network > Show
- Network > TimeZone
- Network > NetStat
- Network > NTPServer
- Network > Unconfigure
- Network > VLAN
- Network > TraceRoute
- Network > Ping
- Network > Hostname
- Network > Proxy
- Appendix F. Main > Monitor
- Appendix G. Main > Settings
- Appendix H. Main > Support
Name
Main > Settings > Alerts > Email — Use to configure email support for the appliance.
SYNOPSIS
Email Hardware Add Addresses
Email Hardware Delete Addresses
Email NotificationInterval Time
Email SenderID Reset
Email SenderID Set Address
Email Show
Email Test
Email SMTP Add Server [Account] [Password]
Email SMTP Delete
Email Software Add Addresses
Email Software Delete Addresses
DESCRIPTION
Use this command to add, replace, or show the email address that the appliance uses. You can use this command to define one or more emails.
OPTIONS
- Email Hardware Add Addresses
Add or append a hardware administrator's email account for Access Appliance to use.
Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.
- Email Hardware Delete Addresses
Delete a hardware administrator's email account for Access Appliance to use.
Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.
- Email NotificationInterval time
Define the time span between the alert emails that are sent to the administrator.
Where time is the time between the alert emails that are sent to the administrator. This variable is defined in minutes.
- Email SenderID Reset
Reset the current email ID to default email ID that is used for the emails that are received from the appliance.
- Email SenderID Set Address
Set a sender email ID that is used for the emails that are received from appliance. Here, Address is the email address of the sender.
- Email Show
View your email or SMTP settings
- Email SMTP Add Server [Account] [Password]
Add an SMTP server that NetBackup can use.
The Server variable is the host name of the target SMTP server that is used to send emails. The Account option identifies the name of the account that was used or the authentication to the SMTP server. The Password option is the password for authentication to the SMTP server.
- Email SMTP Delete
Delete the SMTP server that Access Appliance uses.
- Email SMTP Enable
Enable the SMTP server that Access Appliance uses.
- Email Software Add Addresses
Add or append a software administrator's email account for Access Appliance to use.
Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.
- Email Software Delete Addresses
Delete a software administrator's email account for Access Appliance to use.
Where Addresses is the user's email address. To define multiple emails, separate them with a semi-colon.
- Email Test
A test email is sent to the email Addresses configured above. Check if a test email is received in your mail inbox. The email transmission is decided by the network connections, the SMTP settings and the email address settings of your appliance. Follow the prompted error messages to troubleshoot if the test email is not received.