Please enter search query.
Search <book_title>...
Veritas NetBackup™ Troubleshooting Guide
Last Published:
2019-07-01
Product(s):
NetBackup (8.2)
- Introduction
- Troubleshooting procedures
- Troubleshooting NetBackup problems
- Troubleshooting vnetd proxy connections
- Troubleshooting security certificate revocation
- Verifying host name and service entries in NetBackup
- Frozen media troubleshooting considerations
- Troubleshooting problems with the NetBackup web services
- Resolving PBX problems
- Troubleshooting problems with validation of the remote host
- About troubleshooting Auto Image Replication
- Using NetBackup utilities
- About the NetBackup support utility (nbsu)
- About the NetBackup consistency check utility (NBCC)
- About the robotic test utilities
- Disaster recovery
- About disk recovery procedures for UNIX and Linux
- About clustered NetBackup server recovery for UNIX and Linux
- About disk recovery procedures for Windows
- About clustered NetBackup server recovery for Windows
- About recovering the NetBackup catalog
- About NetBackup catalog recovery and OpsCenter
- About recovering the entire NetBackup catalog
- About recovering the NetBackup catalog image files
- About recovering the NetBackup relational database
Recovering the entire UNIX or Linux cluster
The following procedure applies to the clustered NetBackup server environment that must be re-created from scratch.
Before you proceed, ensure that you have valid online catalog backups.
To recover the entire UNIX or Linux cluster
- Configure the hardware, system software, and cluster environment on the replacement cluster.
- Ensure that the appropriate low-level tape device and robotic control device configuration necessary for your operating system has been performed.
Refer to the NetBackup Device Configuration Guide:
- Reinstall NetBackup on each of the cluster nodes. Be sure to use the NetBackup Virtual Name as the name of the NetBackup server. Follow the instructions for installing NetBackup server software.
Refer to the NetBackup Installation Guide:
- Configure the clustered NetBackup server.
Refer to the NetBackup High Availability Guide:
- Install any Maintenance Packs and patches that are required to bring the newly installed NetBackup server to the same patch level as the server being replaced
- Configure required devices and media and recover the NetBackup catalogs.
- Bring the NetBackup resource group on each node in turn and run the Device Configuration Wizard to configure the devices.
Configuration information on your particular cluster is available.
Refer to the NetBackup High Availability Guide:
More Information