NetBackup™ Status Codes Reference Guide
- NetBackup status codes
- NetBackup status codes
- NetBackup KMS status codes
- NetBackup status codes
- Media Manager status codes
- Media Manager status codes
- Media Manager status codes
- Device configuration status codes
- Device configuration status codes
- Device configuration status codes
- Device management status codes
- Device management status codes
- Device management status codes
- Robotic status codes
- Robotic status codes
- Robotic status codes
- Robotic error codes
- Robotic error codes
- Robotic error codes
- Security services status codes
- Security services status codes
- Security services status codes
- NetBackup alert notification status codes
NetBackup status code: 4313
Explanation: This issue happens for a policy that uses VSO FIM on Linux when a rollback restore is performed on the primary host. The job does not complete if the /etc/fstab
file has an entry with the following configuration:
The policy backup selection is entered as a mount point.
The corresponding device to be mounted is entered as a file system level identifier such as file system
UUID
orLABEL
.
Recommended Action: When you use the configuration that is detailed in the Explanation, of the /etc/fstab
file on the primary host, you must temporarily remove the policy backup selection entry from the /etc/fstab
file. After removal of the entry, retry the rollback restore again. When the rollback restore is successful, you can add the entries back to the /etc/fstab
file.
Click here to view technical notes and other information on the Veritas Technical Support website about this status code.