Veritas NetBackup™ Flex Scale Installation and Configuration Guide

To perform a factory reset on a node

1. Log on to the node on which you want to perform a factory reset.

   Use the following user account:

   User name: admin

   Password: P@ssw0rd

2. From the main menu, navigate to the Support section.

   • Type the following on the command prompt:

     > Support

   • Press Enter.

   
3. From the Support view, run the factory reset command to initiate the factory reset process on the node.

   • Type the following on the command prompt:

     > FactoryReset

   • Press Enter.

4. Specify whether you want to reset the network configuration on the node.

   The Factory Reset command displays the following prompt on the command line:

   >> Do you want to reset the network configuration as part of 
   the factory reset? [yes, no](yes)

   Type Yes to include the network configuration in the factory reset process or type No to retain the network settings on the node.

   The default setting is yes, which means the network settings are included in the factory reset.

   Note:

   If you choose to reset the network configuration, you cannot access the node using its management IP. After the factory reset is complete, you can access the node either by physically accessing the node console directly or using the IPMI network.

5. Specify whether you want to automatically restart the node after the factory reset is complete.

   The Factory Reset command displays the following prompt on the command line:

   >> A system restart is required to complete the factory reset. 
   Do you want to automatically restart the node at the end of the 
   factory reset process? [yes, no](no)

   Type Yes to automatically restart the node after the factory reset is complete, or type No if you want to restart the node at a later time.

   The default setting is no, which means the node is not restarted after the factory reset.

   Note:

   Veritas recommends that you restart the node at the end of the factory reset process. A system restart is required for completing the factory reset process related changes to take effect.

6. Confirm whether you want to proceed with the factory reset process.

   The Factory Reset command displays a summary of the configuration settings and the following prompt:

   >> - [CAUTION]: The node is ready for factory reset. This process 
   cannot be reversed. Do you want to proceed? [yes, no] (no)

   Type Yes if you want to proceed with the factory reset, or type No if you cancel the process or go back and change the factory reset options for the node.

   The factory reset process starts and can take up to 20 minutes to complete. The command line displays several messages that indicate the progress.