Veritas NetBackup™ Status Codes Reference Guide
- NetBackup status codes
- NetBackup status codes
- NetBackup KMS status codes
- NetBackup status codes
- Media Manager status codes
- Media Manager status codes
- Media Manager status codes
- Device configuration status codes
- Device configuration status codes
- Device configuration status codes
- Device management status codes
- Device management status codes
- Device management status codes
- Robotic status codes
- Robotic status codes
- Robotic status codes
- Robotic error codes
- Robotic error codes
- Robotic error codes
- Security services status codes
- Security services status codes
- Security services status codes
- NetBackup alert notification status codes
NetBackup status code: 128
Explanation: In the catalogs that were specified for recovery, one or more cannot be restored. For more detail, refer to the error message that precedes this status code in the output from the bprecover command.
Recommended Action: Do the following, as appropriate:
Fix the problem that was reported in the error message in the bprecover output.
Identify which NetBackup services to shut down before a NetBackup database recovery attempt:
See "About recovering the NetBackup catalog" in the NetBackup Troubleshooting Guide.
The NetBackup services should be shut down except for the NetBackup Client Service, which must be running for the database recovery to succeed.
Check the NetBackup Problems report for additional information about the error.
The following are some possible causes:
A disk may be full.
The NetBackup catalog tape may be corrupt.
Click here to view technical notes and other information on the Veritas Support website about this status code.