NetBackup™ Status Codes Reference Guide
- NetBackup status codes
- NetBackup status codes
- NetBackup KMS status codes
- NetBackup status codes
- Media Manager status codes
- Media Manager status codes
- Media Manager status codes
- Device configuration status codes
- Device configuration status codes
- Device configuration status codes
- Device management status codes
- Device management status codes
- Device management status codes
- Robotic status codes
- Robotic status codes
- Robotic status codes
- Robotic error codes
- Robotic error codes
- Robotic error codes
- Security services status codes
- Security services status codes
- Security services status codes
- NetBackup alert notification status codes
NetBackup status code: 8308
Explanation: The backup image that is used for the NetBackup operation has the data-in-transit encryption (DTE) mode enabled. Therefore, NetBackup tries to encrypt the data. However, the client version is older than 9.1. and as a result restore fails.
Recommended Action: Perform one of the following as appropriate:
Upgrade the NetBackup client to a version that supports data-in-transit encryption.
Change the data-in-transit encryption (DTE) mode of the given backup image to Off using the following command:
bpimage -update -image_dtemode Off -id <backup_id>
Set DTE_IGNORE_IMAGE_MODE = WHERE_UNSUPPORTED in the NetBackup configuration file of the primary server.
For option 2 and option 3, DTE is disabled while the job is performed.
For more information, refer to the Configuring data-in-transit encryption section in the NetBackup Security and Encryption Guide.
Click here to view technical notes and other information on the Veritas Technical Support website about this status code.