Veritas NetBackup™ Appliance Commands Reference Guide
- Overview
- 付録 A. Main > Appliance commands
- 付録 B. Main > Manage > FibreChannel commands
- 付録 C. Main > Manage > HighAvailability commands
- 付録 D. Main > Manage > Libraries commands
- 付録 E. Main > Manage > Libraries > Advanced > ACS commands
- 付録 F. Main > Manage > License commands
- 付録 G. Main > Manage > MountPoints commands
- 付録 H. Main > Manage > NetBackup CLI commands
- 付録 I. Main > Manage > OpenStorage commands
- 付録 J. Main > Manage > Software commands
- 付録 K. Main > Manage > Storage commands
- 付録 L. Main > Manage > Tapes commands
- 付録 M. Main > Manage > Certificates commands
- 付録 N. Main > Monitor commands
- 付録 O. Main > Network commands
- 付録 P. Main > Network > Security (IPsec) commands
- 付録 Q. Main > Reports commands
- 付録 R. Main > Settings commands
- 付録 S. Main > Settings > Alerts commands
- 付録 T. Main > Settings > Notifications view commands
- 付録 U. Main > Settings > Security commands
- 付録 V. Main > Support commands
名前
Manage > HighAvailability > AddNode — Add a new compute node to a high availability (HA) configuration.
概要
AddNode hostname
DESCRIPTION
This command adds a new compute node to an HA configuration by adding the hostname of the new node.
This command is only available before the HA configuration is complete.
Before using this command, make sure that the following requirements are met:
The hostname and IP address must be configured on the partner node.
The model of the two compute nodes must be identical.
The two compute nodes use the same NetBackup Appliance software version.
The new compute node must be in the factory state.
OPTIONS
- AddNode hostname
Use this command to add the hostname of the new compute node to an HA configuration. To set up an HA configuration, refer to the Setup command. The hostname is the hostname of the new node.