Veritas NetBackup™ Status Codes Reference Guide
- NetBackup status codes
- NetBackup status codes
- NetBackup KMS status codes
- NetBackup status codes
- Media Manager status codes
- Media Manager status codes
- Media Manager status codes
- Device configuration status codes
- Device configuration status codes
- Device configuration status codes
- Device management status codes
- Device management status codes
- Device management status codes
- Robotic status codes
- Robotic status codes
- Robotic status codes
- Robotic error codes
- Robotic error codes
- Robotic error codes
- Security services status codes
- Security services status codes
- Security services status codes
- NetBackup alert notification status codes
NetBackup status code: 830
Explanation: All configured drive that can be used for this job are down.
One of the following has occurred:
No drives are configured for the media that was requested for the job.
The job requires an NDMP drive path, but no NDMP drive paths are up or configured.
The job cannot use an NDMP drive path, but these are the only drive paths that are up or configured for the drive.
Recommended Action: Do the following:
Make sure that the drives and drive paths are up and correct for the media that you configure.
Verify that ltid is running on the required media server, and that the media server is active for tape.
Use the device monitor to startup the drives paths if they are down.
If the drives are downed again, clean the drives.
Click here to view technical notes and other information in the Veritas Knowledge Base about this status code.